|
I'd like to array an arrow block along
a polyline with equal spaces for a fire evacuation route. How can this
be done? No problem,
use the MEASURE command. Create a block with the tip of the arrow
being the base point for insertion. Make the arrow about ten feet long
with the tip facing to the right. Call it ARROW. Draw your fire
evacuation route as a continuos polyline. Issue the MEASURE command
and use the command line Block option. Type ARROW for the block name
prompt and set a distance, between fifty and one hundred feet, depending on
the length of the polyline. Your arrow block will be distributed along
the polyline. You may have to rotate a few of the insertions to get
everything to look just right.
|
